1996 Disco rear x member

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
M

malce

Member
Posts
11
Location
Ipstones
Just getting my angle grinder and mig ready to replacing the rear x member on my disco, the questions is do I need to support the body or is this overkill as is is supported in other places, any advise welcome.
 
malce said:
Just getting my angle grinder and mig ready to replacing the rear x member on my disco, the questions is do I need to support the body or is this overkill as is is supported in other places, any advise welcome.
Click to expand...
Replaced mine acouple of years back. Found I didn't have to support the body. On mine the rear body mounts were completely shot anyway . Both ends of the cross member were in good condition so I measured up and cut the new to slot in. Saved having to remove the wing panels.
 
Thanks for the advice I will bo the brace accross the doors as mine is totally gone, seems strange that I do not seem able to buy new rubbers to replace the old ones.
 
malce said:
Thanks for the advice I will bo the brace accross the doors as mine is totally gone, seems strange that I do not seem able to buy new rubbers to replace the old ones.
Click to expand...
Rubbers are available. I replaced rubbers and bolts etc. YRM are good for cross members also supply the rubbers and bolts.
 
You must log in or register to reply here.

Similar threads

G
MIG welding gas supplies
Replies
14
Views
820
Anaconda
A
K2tnt
Disco 1 Discovery 1/2 rear door aperture corners?
Replies
2
Views
584
K2tnt
K2tnt
J
Disco 6 commercial rear windows
Replies
2
Views
555
Graculus
Graculus
R
Am I mad for buying another Disco 4?
Replies
9
Views
1K
lynall
L
S
Disco 1 Disco 1 Rust repair prep
2
Replies
20
Views
2K
sv_dOnut
S
Back
Top