1996 Disco rear x member

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
M

malce

Member
Posts
11
Location
Ipstones
Just getting my angle grinder and mig ready to replacing the rear x member on my disco, the questions is do I need to support the body or is this overkill as is is supported in other places, any advise welcome.
 
malce said:
Just getting my angle grinder and mig ready to replacing the rear x member on my disco, the questions is do I need to support the body or is this overkill as is is supported in other places, any advise welcome.
Click to expand...
Replaced mine acouple of years back. Found I didn't have to support the body. On mine the rear body mounts were completely shot anyway . Both ends of the cross member were in good condition so I measured up and cut the new to slot in. Saved having to remove the wing panels.
 
Thanks for the advice I will bo the brace accross the doors as mine is totally gone, seems strange that I do not seem able to buy new rubbers to replace the old ones.
 
malce said:
Thanks for the advice I will bo the brace accross the doors as mine is totally gone, seems strange that I do not seem able to buy new rubbers to replace the old ones.
Click to expand...
Rubbers are available. I replaced rubbers and bolts etc. YRM are good for cross members also supply the rubbers and bolts.
 
You must log in or register to reply here.

Similar threads

K2tnt
Disco 1 Discovery 1/2 rear door aperture corners?
Replies
2
Views
317
K2tnt
K2tnt
J
Disco 6 commercial rear windows
Replies
2
Views
224
Graculus
Graculus
P
Disco 2 MOT fail, front body mount
2 3
Replies
58
Views
5K
PopPops
P
Sestina
Disco 1 rear differential
Replies
15
Views
742
Stanleysteamer
Stanleysteamer
RichardIStone
Rear Brakes
Replies
4
Views
601
RichardIStone
RichardIStone
Back
Top