Search results

Elp! I have searched and cant find a definitive answer... R reg 98 50th anniversary 300 tdi. Disco had a new battery last week after old one died. Changed battery started up first time - great me thinks. Then locked up and went inside. Came out later, fob didn't open locks then...

Unfortunately fella, you'll find there were far more than 50 made. Good luck with the number though.

sprog -PM sent. Cheers Steve

First dibs on dog tail gate guard please. How much please. Also how does it fit to vehicle?

Had similar on my 300 tdi, check to see if the pads are rattling in the calipers. Good Luck.

Should be fine especially on mud terrains, they'll cope with the stones easily. I can't remember what size tyre was the best for your disco, probably best post another thread asking what size tyre is best........

And it came from Halfords :D:biggrin1:

Check the stud that the tensioner goes on, its a steel stud that goes into an alloy casing, the thread quite often gets chewed up and fecked. If the stud won't tighten properly, its not the tensioner, but the stud, which is an easy and cheap repair with a m10 x 1.5mm helicoil kit ( about £20...

1.1jp - Thanks for your lack of response...... I Withdraw my offer to buy from you, I have now got some wheel nuts elsewhere, also bought a viscous fan, timing case cover, spare wheel cover, and other bits from a chap who actually bothered to reply. You have been online several times...

Why fourth and difflock??? Dunno, thats wot I read to do.

Mr Noisy, picked up timing case and new fan £30. Took timing case off, after buzzing the crank bolt with the starter.Belt looked good, and sticker inside said belt was changed 2010 6000 miles ago. Took my time, slow and methodical, verging on anal, put all the bolts in separate little bags...

Oi Mr Noisy, you're fecking worng, it wasn't poor technique - actually it was no fecking technique...... Seriously, we all have to start somewhere and learn ( even if its the hard way :doh::doh:) Thanks for all your help guys

Cheers guys, fab service from LZ yet again.

Thanks James, that part seems to fit on front of pulley on Red's link, Crankshaft & Bearings ??? LandRover Discovery Series I 1989-1998, Engine The one I have was on back of pulley. Is it the same thing.

Cheers Red, it doesn't seem to be on there.

Any idea how I find a part number, is there a full 'catalogue' of parts available?

Ah ha, sooperb. James you are a genius, thank you.

I get 31mpg from my 300 tdi manual, on a run from south wales to scotland with a 5'x3' trainer behind. Usually about 27/28 for normal driving. Egr and cat less, 80/20 road tyres 32psi front 36 psi rears.

Evenin all..... Took my crankshaft pulley off tonight to remove timing case. On back of pulley fitting very tight to the back of the pulley there is a dish/cupped ring, which is almost rusted through. What is this part called, and is it available without the pulley. Thanks

Thank you ppeps, for you help and suggestions. I got the Timing case off tonight, seems that fan aint never gonna shift. Got a new ( 2nd hand ) one on way.