Search results

Hi Scotchgit Yes you have cracked it its running. I was thinking to hard again instead of being logical. Thank you Mick

Hi Peter Yes I swopped it with a couple of different relays I also tried swopping the Key relay but still the starter is disabled. Also gave the gearbox a couple of changes between Park and Neutral just in case but no luck. Thanks Mick

Hi All Please can anyone help just done 450 miles in 4.6 P38 gone home took the keys out and everything turn off except the engine. had a mess around putting keys in and out switching things on and off but still the engine was running. In the end I took out Relay 19 which stopped the engine...

Hi All Thanks for the advice. I have just read a post for a different fault by Mr Noisy where he says try disconnecting the battery I have done this and all faults have cleared. Don't know if it will last but it seems a reboot of the BECM has done the trick Thanks Datatec for the tip on...

Hi All Please has anyone got any ideas on the fault below With engine running Headlights and dashboard flashing on and off Central locking stopped working Electric windows stopped working Headlights and side lights will not turn on or off with switch Clicking under passenger seat which I am...

Hi All t Thank you for your advice I put a VC on at the weekend which cured the steering vibration and the tyre grabbing (What’s left of the tyres) I managed to get the old one off and the new one on without removing any of the gearbox mounts. I now seem to have a different vibration...

OK Thanks I do have two and both are the same so as at the moment it’s my only option I am going to fit one of them. I will let you know outcome.

Hi Thanks for your reply. You have solved the problem I have put it in neutral and jacked up a front wheel it is solid will not turn. I have a spare Transfer box in the garage with a viscose coupling on it and with a standard size ½ knuckle bar holding the brake drum and just a ½ racket on...

Hi Everyone Please has anyone got any ideas? P38 4.6 The steering started to vibrate slightly and wonder especially on uneven roads. Changed the damper (no improvement) Adjusted and then changed the power steering box (no improvement) Thought I could hear the vibration on the right hand...

I think I will now get a top hat linnered block and start again.

Hi All Thanks for your help and advice I had come to the conclusion that it was the block that was cracked when somebody told me about this super sealing liquid from the USA. Well it goes like this being as it had not got to the pressurising point for two days I thought I would get some of...

Hi Yes they do and it does seem to have a lot of pressure when I remove the filler cap.

Hi All Help Please 1998 Range Rover 4.6 Overheating. Story so far is New big end bearings and piston rings. New water pump, New thermostat, New temperature sender, Rad was new 5 years ago so should be ok, heads skimmed and new head gaskets fitted. New LPG system (Overheats on LPG and Petrol...

Sorry forgot the website its www.rswsolutions.com

I was once driving down the M1 when the exhaust started to blow this went on to burn the three air pipes which run down the top side of the chassis. Good idea is to fit sone Ts to the air pipes under the bonnet and then put some valves on them so in an emergency you can blow the EAS up at a...

Hi All Please have any of you got any tips on taking the engine out of a P38 especially splitting it from the gearbox and auto transmission pipes.

Hi thank you both for the tip while I was checking the wiring I found that I had plug in the wrong socket to the right hand coil. I plugged in the grey socket which goes to the cylinder on top of the air intake which fitted perfect. After putting the plugs the right way round all worked OK...

Hi All Thanks for looking at my post I have somemore information after pluging the car into a cheap £20 OBD tester it came up with these two fault codes. P1510 Short circuit to battery - Opening Winding p1553 Short circuit to battery - Closing Winding

Hello All I have just replaced the head gaskets on my 4.0L discovery 2 and now have an ignition fault. When I first started the car it would not tickover I put spark testers on the plug leads and noticed that on cylindas 1,4,6,7 the spark testers were glowing very dim while cylindas 2,3,5,8...

Hello Again Thanks for your reply. I have this system on my disco you know the one, which is waiting for me to put the heads back on. (still bidding for stud extractors) Its my P38 which is having the gas problems. I have tried allsorts to get this system running properly. Last night...