Search results

I have for sale a pair of timing belts and a tensioner and the rare LDV pulley all NOS to suit the 2.5 diesel engine that was fitted in the LDV sherpa vans. I cannot remember the J number of the engine but know it has the tin unsealed timing belt housing and its the rare one to get parts for...

i have a full set of genuine seat heater mats for both front seats for p38 leather interior heated seats. make me an offer for the 4 new mats. 07973 145490:)

i have an l322 parcel shelf in charcoal for sale in good clean order not tatty. make an offer nick 07973 145490:)

I have a L 322 parcel shelf for sale second hand in very good condition with no rips or tears. It has a strip along the front edge which had been cleverly added to keep it strong as these are weak it sits behind the seat which I think reinforces the fragile front end of the shelf which has flat...

I have a spare good condition l322 parcel shelf in Charcoal with no rips or stains etc used condition and handle and pegs all intact and it would be a good replacement for one missing or damaged. I will let it go to a fellow landyzone member make me an offer? what is it worth.? I dont fancy...

Hello. I am wondering as to the cigar lighters and illumination. Do they light up in your L322? I have one in the centre box, one in the rear seating area and one in the front. I see a green bezel, rave indicates lights on the wiring diagram however I have inspected the two in hte front and...

Hello I have a issue with my alarm. The interior sensor does not pick me up if i am inside and ive armed it even after opening and closing a door. the LED seems to flash at the armed rate not faster for 10 seconds as rave suggests so its arming immediately suggesting sensor issue. fuse is ok...

my wipers work ok on intermittent and speed 1 but speed 2 seems no faster. tbh speed 2 is slower when the blades are on the screen. any ideas could it be relay 8 or motor? nick.

hello folk .does anyone please have the little black runner clip blocks that fit in with the sunshade im recovering mine as the fabric fell off but one seems split. kind regards nick. willing to pay etc.

4.0l v8 p38. Had the wagon over a year and it has been fine, replaced radiator which was original and had a small hole in it, and a couple of hoses which had been damaged by an eejit using plyers to remove them!! not me!! last year. It has not lost any coolant and has a clean red antifreeze mix...

spotted this a P38 burning in the riots. Scum they are!

Evening, Can any one tell me the part number for the high pressure hose / pipe that runs from the pump to the condensor? its the smaller one of the 2 and it has somehow developed a pin hole in the rubber bit leaking green aircon fluid etc. Why has this gone? is it age? system was regassed last...

Hello peeps! The cable has snapped behind the pull handle I have ordered a new one however is there enough slack on the latch if I unbolt it to access the other end to fit the crooked end of the new cable will I need any clips that break etc ?? Or am I worried unduly? Thx nick

Hi Folks, I have noticed in the cold weather that my air con pump seems reluctant to kick in when selected on hte a/c hevac panel, ie lo is selected on heat and pump light off. Is this beacause the interior sensor is seeing its too cold in the cab? or is it because the exterior sensor is seeing...

Hi Team, I seem to have a weird issue with p38 1997 SE windows, sunroof and mirrors. I got into the car today and basically nothing on the centre switch panel would work. If I remove fuse 1 which feeds power to the centre switch pack outstation then on trying again the windows work and work...

I've noticed today the blower seems to send air to the footwell all the time ie if I select face vent it moves to the face vent and blows out the face vent leaving the footwell but footwell seems to still get some blow same with the screen setting too which shuts off face and moves to screen but...

1997 4.0 V8 P38 I have reciently changed the radiator, and renewed the antifreeze bleeding the system as per RAVE however today I have noticed when the engine is running there is small bubbles rising from the bottom of the expansion bottle. I reckon there must be a leak on the head gaskets am I...