Hello peeps! The cable has snapped behind the pull handle I have ordered a new one however is there enough slack on the latch if I unbolt it to access the other end to fit the crooked end of the new cable will I need any clips that break etc ?? Or am I worried unduly? Thx nick
Drivers interior handle P38
- Thread starter NickNorth
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
rewmer
Well-Known Member
- Posts
- 2,082
- Location
- Clacton, Essex, UK
Not sure on the question here. If you are thinking of try to replace it without removing the door card then your in for a battle. The card will come off in a couple of minutes, save yourself the struggle.
996TURBO
Active Member
- Posts
- 579
- Location
- Paris, FRANCE
You're on the good track. Remove latch to install all cables and rods.
kooky_guy
Well-Known Member
- Posts
- 2,410
- Location
- Sandhurst, Berkshire
You need to unbolt the latch to stand any chance of getting the cable connected to it. I couldn't even get the end of the broken cable out of my latch until I unbolted it.
You should be ok in terms of clips. The one on the internal door handle was a bit of a pig on mine and I was sure it was going to break, but it didn't.
You don't need to move the latch much to give you the clearance and visibility you need and it bolts back in again very easily. Well, mine did.
You should be ok in terms of clips. The one on the internal door handle was a bit of a pig on mine and I was sure it was going to break, but it didn't.
You don't need to move the latch much to give you the clearance and visibility you need and it bolts back in again very easily. Well, mine did.
