Search results

after changing the oil pump in my p38 zf24hp gearbox petrol and refitting the gearbox with new oil and filter the reverse is only crawling a bit. whatever I try with driving or shifting ,,,no luck....... Before the job everything was doing ok. would lucas fix help or is it just bad luck...

while changing the starter ring gear the torque converter came out a bit.we pushed it back and finished the job. The automatic gearbox won t shift anymore .It indicates gearbox fault or traction fault. The only thing we also did was changing the oil because the sump screw was leaking. We are...

p38 gems 1994 4.6hse Within 6000km the ring gear and starter are damaged again.It starts but often with crushing noise. I hoped it would be better with a brand new starter .....but .the gear has at the dead point too much damage. I do not have time coming months to change the gear so my...

P38 1994 4.6hse had bad start when warm .replaced the crank sensor .problem still the same .Checked all the wiring up to the ecu .What could i do next

my p38 4.6hse 1994 lpg prins injektion starts very bad when half warm.(petrol) Cold start is good (petrol) When maximum temperature it stars automaticly on lpg so no problem.So it could be the crakshaft sensor. I tested it by removing it and then starting with cold engine .....no start. So the...

p38 4.6 prince multipoint lpg 1994 After replacing becm (earlier thread) engine starts fine on petrol when cold en goes smoothly into lpg modus. When warm it does not start on petrol until the engine cooled down fully. I changed the crank sensor last year.I read that the car will start...

In an earlier thread a had a becm lockout .I had no keycode and tried syncmate. I found the previous owner and he told me becm immobiliser was disabled .I phoned his garage and they told me the becm was send to a specialist to disable the becem. Well the display asks now for a keycode and...

p38 lhd 4,6 After a new rh doorlatch my p38 asked for a keycode.Because a previous owner changed becm I use sync mate to synchronise,I hear the becm clicking so it is making contact with sync mate. With multimeter I checked all wires and coonection ......nothing. What problem could block the...