Search results

Hi Guys i have a strange overheating problem from startup Start the car when cold and the temp slowly rises on the gauge until it gets into the red then the thermostat opens and it goes to normal and stays there never moves, when it gets to the red if i get out and take the cap of the reservoir...

Hi all can you get drive flanges for a 1984 Range rover classic lots seem to be listed for newer after 1986 ones but can't seem to find any for before 1984, anyone with a part no ? Or am I missing something like they are supposed to be one piece half shaft and flanges Thanks all

Hi Guys I'm normally in the series and defender section but I've just purchased a 1983 3.5 V8 Carb Range rover and I was thinking of removing the centre silencer for a bit more throaty V8 sound, is there someone who makes a straight through pipe to replace the mid box ? Is it with it ? Has...

Hi Guys just got my hand on another series-3 and I've got a bit of a strange 4x4 problem, I seem to be permanently in 4 wheel drive, now when I push the yellow knob down and then try to take it out of 4x4 by pulling the red lever back then forward the yellow knob pops up and then when I push the...

Hi Guys I've just put a newly built reconditioned gearbox back into the series 3, everything was going fine on the first test drive until I go down a hill, it seems to jump out of gear, now this happens on all gears, have I done something wrong? Was thinking the main shaft castlelated nut might...

hi all anyone know what brake uinion sizes are used on the below master cylinder its for a early 90 but im using it on a series 3 88 that ive converted to front disc brakes, it fits straight on the series 3 servo but im not sure what the sizes of the unions will be. Also does anyone know which...

Hi everyone do any of you know if the 109 4 cylinder front back plates and the 109 6 cylinder / V8 back plates are the same and its just the slave cylinders that are different? I have a set that I think has come off a 109 v8 and I want to use them to upgrade my 88 front brakes so I want to use...

Hi all just about to put upgraded rr classic diffs in my series 3 one has been completely rebuild and the other is a good used unit, which one would you put in the front and which one in the back. my theory is because I have freewheeling hubs I'd put the used one in the front. what do you all...

Hi is there such a thing as a rear spare wheel carrier that could be used on a 88 soft top with a drop down tailgate Im sure ive seen one somewhere and now i cant find it Thanks Cris

Hi all my old girl was first reg 4/03/77 so in theory she is approaching 41 years young when can I have Historic road tax ? as Im getting conflicting advice, DVLA told me yesterday i could have it now so went to the post office with the relevant documents and there computer says no, so rang dvla...

Hi all think i know the answer but just want to be sure Will a Discovery 200 tdi 10 spline FRONT diff fit the REAR axle of my series 3 sorry for caps just wanted it to read clear Thanks Cris

Hi All My temp gauge on my series with a 200td defender engine is reading a tad hot I thought it was the common problem of the 200 temp sender not being right for the series 3 temp gauge, so I ordered the Steve Parker conversion adaptor and a original series water temp sender, The thing is It...

Hi guys would a ninety brake pedal box fit a series 111 land rover Im wanting to convert to servo brakes and was thinking of using the 90 set up on a series 3 servo, Im sure Ive read somewhere that this will work unless I have dreamed this as it sounds way to simple. Has anyone done this and do...

Hi all i have a 1977 series 3 with a discovery 200 di conversion it just has the metal throttle rod linkage to the fuel injection pump and it has always done a bit of kangarooing but since i put new parabolics on the front its amplified it ten fold, so im planning on putting a defender throttle...

Hi all hope your enjoying the weather Iv'e got a series 3 with a 200 di engine in and the alt belt is slack but adjusted fully so i think its the wrong belt this one is 13mm x 1100 does anyone know the correct size of a 200 tdi alt belt before i order one, Im also thinking it might be the wrong...

right series 3 with a fairly new set of parabolics on the back and standard rusted up good for nothing ones on the front its all sitting very level at the moment and I'm wondering whether to change all four for new paras or just the front, my thinking is change all four but I'm open to...

Hi everyone I have had a Land Rover in one way or another all my life until recently that is, I made the mistake and bought myself a new 90 puma a few years ago and it proved to be the biggest mistake i every made in my Land Rover life, Any way its gone now and i'm now in the...