Search results

Hi all, I am about to do my injector seals as I have a little diesel in my oil. What I want to know is should I change the oil and oil filters before I take the rocker cover off and inspect/remove the injectors for leaks and change the seals? If I don't then when I inspect the injectors - it...

Hi, my oil level seems to be creeping up. 2000 TD 5. I have bought a new and genuine set of injector seals - but I may have to suffer a new head. Some questions. I think my replacement engine is a 15p, how can I tell? Are the 10's and the 15's the same head - if I have to replace it. How...

Hi, please forgive my ignorance. I am here to share all that I don't know! When you remove the ABS sensor should there be grease on the end of it or down the aperture ? Thanks Adam

Hi, here I am again. After a wheel bearing, CV joint brake rebuild, I drive it out of the garage and the TC cuts in and binds up the side of the drive that I have been working on. I am completely baffled. The bearing was from Craddock so I am assuming it is a proper 60 tooth ABS model, but I...

Hi good folks. Just reassembling after changing upper and lower front ball joints. Torqued the collet up to 5 its and the top and bottom nuts of the hub/knuckle you can see in the photo up to 55. My question is that the hub is very stiff to turn when I grip it with both hands. Is this normal...

Hi folks, just to make sure I've got this right, when reassembling the steering knuckle to fit back onto the balljoints the collet should be tightened all the way? Thanks Adam

Hi, I just wondered (A) do I need to do anything other than mechanically install a replacement ABS pump. Do I have to program it into the ECU with a VIN number or anything or is it plug and play. Also someone had a really brilliant way of expelling all the air manually without the Hawkeye. I...

Hi there, I know there are lots of threads on bleeding the Discovery 2, I have read all of them and followed all the advice and have got no further. So, my brakes lines burst during 1st lock down, I wasn't going anywhere so let it sit dry. Eventually changed the lines, flexes, Master cylinder...

Hi there, please help. Only a day or so left before retest runs out. I replaced both ball joints on my D2 TD5 and I can't get the steering swivel or hub carrier to sit up enough on the new ball joints. I've tried the press I used to get the ball joints out, even the jack underneath, but there...

Hi, about a week ago I changed the front hub bearing which made a wheel bearing type noise upon reassembly, which was a bit annoying as the old one was silent. The advice was dud bearing or warped discs. Well I have fiited a new bearing and discs and the noise is still there, which is even more...

Hi, to get through the MOT I had to replace the lower ball joint rubber, and while I was in the i decided to change the wheel bearing. After putting it all back together and test driving it I am getting a horrible wheel bearingish noise from the new bearing. It also feels as though it's binding...

Hi, I am new to the forum and to the Discovery. I absolutely love mine and have enjoyed changing the transmission fluids, the tailgate actuator and generally getting to know it over my first 800 miles. I am Ggenerally used to sports cars (old Alfas in particular) so it's a revelation sitting...