Search results

Thanks. for all comments . all parts setup to workshop manual. will check everything again. Thanks Steve

HI Steve2286w When 3 flexes clamped pedal solid remove rear clamped flex pedal still solid. remove one front flex pedal moves slightly. remove the other flex moves slightly but pedal spongy seems like air but cannot get rid of it completely tried 101 ways. springs all correct Regards Steve

Good evening,Could someone please tell me if the brake shoe anchor plates/ tennis rackets, should be on all four wheel axles or just the rears, as mine are only on the rears ,on looking on line I have seen them on the rear axles but some without on the fronts. Does it matter on which shoe the...

Thanks everyone for your advice Steve

Hello everyone. I am in need of advice again but about the water hoses needed for my series3 with a 200di engine I am about to fit the new series 3 radiator. but the engine is a discovery 1 DI engine. what and were is the best place to get radiator hoses for this setup as the radiator outlets...

Thanks for all your help did not realise there is a small trunion now got the idea Regards Steve

Good evening everyone, could any body please tell me how the short heater cable is attached to the two flaps located in the lower dashboard ,and if possible a picture Thanks Steve

Good morning eveyone. I am looking for some advice how to set up my bulkhead to tub alignment.What is the best way to set up the fixing of the tub and bulkhead as I have a new chassis and galvanised bulkhead and I am starting to reassemble these back on the chassis but unsure how to...

Hello everyone, Just after some advice I am part way through a re -chassis of my series 3 but when preparing one of the doors for painting several weeks ago, found a few tiny corrosion bubbles about 25 mm from the bottom of the door . I cleaned them off and filled and smoothed off ready for...

Good afternoon all.Just some advice needed regarding Bulkhead. I have just recieved my series 3 bulkhead back from repairers Galvanised .I have T washed it so paint will key to it better.but it needs some small dents Filling and needs some seam sealer around odd seams ,when is the best time to...

HI it seems to be the best solution as I have only medium compressor/spraygun and a limited room (small garage) and in a built up area.(neighbours) Regards Steve

Evening everyone. I am about to respray my series 3 Land Rover.With Deep Bronze Green /Limestone gloss celullose paint ,But would like some advice as the best supplier or brand of celullose to use,as it is years ago since I used any celullose. Iam looking at using about 5ltrs./green /2.5ltrs of...

Hi. Blackburn Just looked at your diagram and the terminals are the same on my PRC2735 and the large o/d diameter is 54 mm and the smaller dia is approx 47mm.As soon as I get back my bulkhead and get a new wiring harness I will try the wiring colours/terminals to your diagram. Thanks again Is...

Hi Extreedoc. All the cable insulation/wires badly burnt to copper.regards Steve

Hi everyone,more info needed again,I am in need of electrical help.I have a 1980Series swb estate with a Discovery 200tdi engine very badly fitted. I am in mid restoration,refitting with new chassis and awaiting refurbished bulkhead,but trying to sort out wiring.I will have to source a new...

Thanks for the picture info Blackburn, but could you please tell me were the terminals go to and come from as the wiring diagrams I have seen only tell you the basic position of the parts and not were the terminals fit and what they fit to Thanks Steve

Good evening all ,I am after help with relay problems. I have a series 3 swb estate with a discovery 1 200 tdi engine in it but the glow plugs are not wired up . I have seen wiring diagrams on how to adapt the discovery glow plug relay/ timer to a series 3 .The timer /relays are easy to obtain...