Recent content by rowlesy
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
R
is there likely to be springs and such popping out all over the place?
-
R
can you take the riveted end off and replace the gasket on them? mines squirting oil! works fine bar that!
-
R
im after some for project. wings doors tub and bonnet. anyone in the west mids / worcs break em?
-
R
adjusted vernier again today - advanced until it was knocking then backed off until it just stopped at tickover. still the same topped out at 60 on way home. so ive wound in low boost adjustment a full turn and took her for a spin. a few hills round here and she felt like it pulled betterer? and...
-
R
20 quid for 100 miles i wouldnt be too bothered - mines a manual so 30mpg+ should be easily achievable - plus mines not pulling too well makes me think i should just buy summat else smash this thing up! last run was calculated at 20.92mpg! i should of bought a v8 and gassed it!
vernier has been...
-
R
done tappets today - had a couple that were tight so altered those and re checked the lot made no difference still doing 100miles to £30 diesel.......
turbo seems to give me a kick at 2500rpm onwards but i hardly ever seem to be at 2500 unless im gunning it? any ideas?
-
R
these boys obviously don't know where the 1/4 is....:rolleyes:
-
R
i'll have a mooch when the rain stops!
-
R
yes the pump was altered to suit the cam. when i refitted the new cambelt kit i couldnt match my lockpins to the indicator markings on the casings so had to slacken off the pump vernier to get it all lined up again. after the engine turning by hand for what seemed like forever to make sure - i...
-
R
ive blanked my egr - decated it - emptied the sedimenter fitted a new lift pump nowt nothing nada!
could do with getting measurments for the pump washer to eliminate that.....
-
R
had my disco for about a year now and it was bought as a bit of a fixer upper. after a lifetime of welding it was pressed into service but what a disapointment its been. ive had a few 200's and the missus has had a few 300's last one being an auto - which was much quicker than my current one. i...
-
R
look up trailer hire on google
-
R
on the first page there is a picture showing starwheel plastic collar and spring. on taking my pump apart to tweek i have found there is no spacer? what would the implications be of not having one? its the first time its been opened as far as im aware as theres only one line worn into the pin...
-
R
adjust the slack in the cable! fit cable and poke it thru tunnel into cubby box - then fit plastic collar and slide over top clip then attach to hand brake lever. give a few pulls to get everything home and then adjust drum shoes. after youve done that and your cable still feels crap turn the...
-
R
front wheels up in the air - engine off - turn steering wheel & check for freeplay in the steering box
ive done mine today along with a few other jobs.
i had a constant pull to the left and a wander on - adjusted backlash on the box (turning and adjusting 6mm allen in) and wound out front tie...