Recent content by fastfun1965

bloody great chain around the steering wheel and pedals with a padlock saves any need for locking it up and doubles up when you need to winch yourself out you have a chain to go around a sutiable ground anchor

these will bend a con rod with a the smallest amount of water in the bore you have to remember water CANNOT be compressed the rod has to give

mine has spent the day being thrashed around yarwell off road quarry

have replaced them under the car with only that end of the prop off gclamp hammer and drift but a good set of circlip plyers is a must if the prop is loose

it would judder like hell from speed if you had a warped disc

ddont like to say it but take the glow plugs out insulate the wire and spin it over have had water seppage through heag gasket into bore hydroliclocking the engine or have you tow started it

have just put a used 2.0 turbo out of an mgzr in a freelander its still a pile of crap but it now moves should have done the repairs on the mg and scrapped the freelander but the boss didt listen till its to late

lol ricc and besides thay have to get the damm thing to start then thay can show me how

from my dealings with this call it pedal judder just before comeing to a stop on all sorts of motors french /german even 6.5 ton iveco it always comes down to a wheel sensor being out of range ie wrong air gap or the abs ring toothed ring around the drive shaft being full of rust/mud so the...

there still well over a £100 and it can only be a matter of checking the castor angle of a standard set up cut the brks of the axle and weld them or new ones back once the axle has been rotated the ness amount to bring the castor back into line unless i am not thinking iit through properly hence...

i would start with the air gap on the new sensor are thay the push in type

worried about theft hard wire an old smart phone in the car with a pay as you go sim card leave the phone on and track it on your computer well if it gets nicked can test it for real but seems to work

p.s how do i add photo computer dont like ballpain hammer

well now what i need is an old axle case to play with watch this space i have all ready made steering /diff / tank covers 2 inch lift shock droppers and 60 mm spacers fitted extra large def arches and a roof bar that was a book case

a long 1/2 ext bar on the nut corner then a sharpe tap with a hammer always works for me