I have an xbrake disc handbrake conversion from x-eng. I have just replaced the pads in it because they were very worn but it is now binding.
Having replaced the pads off the vehicle I cannot get the disc In between them. Both pads are seated correctly in their repspective channels and are all the way home. The pads themselves just seem to be too thick.
Before I sand the pads down so there is enough room to fit the disc has anyone else had this problem?
Or have any suggestions of things to check?
Having replaced the pads off the vehicle I cannot get the disc In between them. Both pads are seated correctly in their repspective channels and are all the way home. The pads themselves just seem to be too thick.
Before I sand the pads down so there is enough room to fit the disc has anyone else had this problem?
Or have any suggestions of things to check?