window won't set

Hi
The left hand front window stopped doing it's one touch thing and is proving impossible to set. It works normally without any undue noise but just will not set. Also the left hand rear works when it wants. Will it be a faulty switchpack?
Regards
Mik

Hi
Dosn't any body have any ideas on this one it would be very helpfull to get a bit of input.
Regards
Mik

Have you tried opening the window fully and then closing and repeating. I normally have to do this everytime I remove the battery.

when you say 'without any undue noise' are you say there is some slight clunking there or something??

When putting the window up does it remain straight and level all the way up??

-Wills

Hi thanks for the replies. Jamie I have tried for a week to reset the window but it won't set.Wills there is no clunking or mechanical sounds and the window is level. The only thing is when the window is fully up or fully down and you press the switch there is a slight click as if the motor cutout hasn't done it's job, this dosn't happen on the other front window.
Regards
Mik

When setting the windows you need to lower them and keep the switch deppressed for 2 or 3 seconds in the down position before raising the window and again keeping the switch deppressed for a couple of seconds! This should do it. If you have clunking noises you may have a loose regulator fixing bolt!

Hi

I had a semilure problem with mine. It wasnt until I took the door card of I found the rubber seal had fallen out of the track and was laying in the bottom of the door. But also 2 of the reviets that hold the window mechanisum had sheared off. Easy enough to fix, problem sorted

Bryan