Pauliil1948
Member
- Posts
- 20
- Location
- Airdrie
hi guys , 2006 Freelander td4 , one off the hoses is burst not sure what one order as looking under bonnet left hand side it's a rubber hose ,any help would be good thanks ,
Whistling noise
- Thread starter Pauliil1948
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
freelance
Well-Known Member
- Posts
- 8,466
- Location
- essex and beyond
Turbo to inter cooler hose, or inter cooler to inlet manifold hose, probably best to replace both with silicon ones
Nodge68
Well-Known Member
- Posts
- 32,504
- Location
- Near Newquay
You want this http://www.island-4x4.co.uk/interco...or-mount-0306-britpart-pnh500190-p-25526.html.
Or fit a full set of aftermarket silicone replacements, which is what most owners do.
Or fit a full set of aftermarket silicone replacements, which is what most owners do.
Arctic2
Well-Known Member
- Posts
- 2,456
- Location
- Westmidlands
Intercooler hose which goes to the EGR through the top plastic air intake, I fitted these below to my TD4 when I had it.
https://www.ebay.co.uk/itm/LAND-ROV...hash=item43cbde39a4:m:miMrYYVDLbJblIZP4h9v2ew
https://www.ebay.co.uk/itm/LAND-ROV...hash=item43cbde39a4:m:miMrYYVDLbJblIZP4h9v2ew
teddywood1
Well-Known Member
- Posts
- 5,558
- Location
- stoke-on-trent
i had mine from DPH and I have had 2 sets as I left my old car with them on but they seem not to want to listen to me I did phone them the one that comes of the egr and goes to the inlet system is actually to big for the end that goes onto the inlet it is about 4mm difference to the egr end
Arctic2
Well-Known Member
- Posts
- 2,456
- Location
- Westmidlands
It is also a little long therefore if you cut it back a bit as in the photo's below it fits perfect, I used the cut off to put over the intercooler pipe to stop it rubbing on another pipe /hose
