wheel arch trim

a SAAB driver getting out of her car opened her door not looking in her mirrors her door went into our rear passenger wheel arch cutting through the body trim. Repairs through insurance NFU, the garage has removed the damaged trim which they admit ripping off as it was bonded to the body, what they didn't do was check if they could get a replacement part and if not bond the rip in the trim.
As it stands now the trim is in too many bits, phonecall this morning option to take all body trims off and paint finish the body, the part required is the rear is the rear passenger trim- can anyone help sourcing the part

depends on the model. but give johncraddocks a bell and tell em what you are after
John Craddock Ltd - Specialists in Land Rover Parts and Spares

hmmm, not sure exactly what bit you are after, is is the plastic bump strip thing that's half way down the door running from front to back but just the piece for the rear passenger door??

-Wills

You have not said which Range Rover it is for.

P38

Body side mouldings are available from Rimmer Bros, either a complete set or each moulding separate.

If you are are talking about the wheel arch mouldings these were not standard, you have to buy the complete kit and adhesive available from Rimmer Bros also.

The mouldings for the Range Rover classic are available also from Rimmers, either aftermarket or genuine.

P38 1988 HSE 4.6
Thanks guysxwill contact
Rimmers

paddock,s at matlock are good for bits , cheaper than craddocks aswell