fella31
Active Member
- Posts
- 293
- Location
- Buntingford, Great Britain
Whats all this around my pipe..(pic)
- Thread starter fella31
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
fella31
Active Member
- Posts
- 293
- Location
- Buntingford, Great Britain
The car is a Disco TD5 (2002) auto.
iannotts
New Member
- Posts
- 4,401
- Location
- East midlands,
water residue, nowt to worry about 
- Posts
- 3,275
- Location
- Rushden, Northants, UK
It is water leakage, what you can see is the antifreeze crystals left behind as the water evaporates. Might be some rust in there as well.
Get it fixed, it won't improve with time and will likely get worse when you are miles from anywhere.
Peter
Get it fixed, it won't improve with time and will likely get worse when you are miles from anywhere.
Peter
fella31
Active Member
- Posts
- 293
- Location
- Buntingford, Great Britain
To repair it do I need to get a new hose or is there a way to tighten the clip to stop more water evaperating?
Cheers
Al
Cheers
Al
thebiglad
Well-Known Member
- Posts
- 7,387
- Location
- Central France
Hi Al, I would say that the best way to do this is with a new hose and a new clip. Then you know you are back to how it was when it left the factory, brand new !!
- Posts
- 3,275
- Location
- Rushden, Northants, UK
Don't use those awful spring clips, buy genuine Jubilee clips.
Clean the radiator pipe stub with wire wool or a green pot scourer to leave a clean and smooth face for the new pipe. Use washing up liquid (undiluted) if the new hose is tight to go over the stub.
Peter
Clean the radiator pipe stub with wire wool or a green pot scourer to leave a clean and smooth face for the new pipe. Use washing up liquid (undiluted) if the new hose is tight to go over the stub.
Peter
discool
Well-Known Member
- Posts
- 13,627
It looks like the problem is with the gland and the rubber seal of the electrical connector, what ever thats for. The hose clip only has a few rust spots on it
martinhollings
New Member
- Posts
- 659
- Location
- newark/nottingham
get a new hose when i got my disco it had 2 clips on and still leaked make sure the you clean it well before fitting the new one and take note of the routing of the pipe that drops down the side of the engine that it dont rub on the power steering pipe
fella31
Active Member
- Posts
- 293
- Location
- Buntingford, Great Britain
Cheers guys !
mad mechanic
Active Member
- Posts
- 268
- Location
- south yorkshire
have to agree it looks more like the sensor is leaking..take it out clean it up and see if the sealing washer or compund is still intact if not fit a new washer (usually copper or alloy) or smear a little gasket sealer on the threads before putting it back in. you could take the hose off and see if any coolant residue is on it if not, again clean it up and refit using a proper jubilee clip.
hth andy
