What is this?
- Thread starter Beaver
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
the_wolf
Well-Known Member
- Posts
- 16,791
- Location
- Stonehouse, Scotland
It's an industrial strength dildo
mick the builder
Well-Known Member
- Posts
- 5,901
- Location
- Sligo,Wild West of Ireland.
Lining up wheel studs?
bushwwacker
Well-Known Member
- Posts
- 6,154
- Location
- Here
Priest?
Fooking mahoosive urethral sond?
Apprentice piece?
PTO insert for a butt plug?
Fooking mahoosive urethral sond?
Apprentice piece?
PTO insert for a butt plug?
About 19mm at the thin end and 30mm at the fat bit.
Last edited:
- Posts
- 83,232
- Location
- Embasinga stocæ
clutch alignment.
wattfield
AKA Dirk Diggler
- Posts
- 27,697
- Location
- Ayrshire-by-the-puddle
What's it made of, how heavy is it, and are there any marks on the ends?
No marks and it weighs 18oz. It's made of metal!
wattfield
AKA Dirk Diggler
- Posts
- 27,697
- Location
- Ayrshire-by-the-puddle
"Metal" covers a few different things, but the weight was the point!No marks and it weighs 18oz. It's made of metal!
Still don't know what it is, I was just curious. Heavy, aint it?
the_wolf
Well-Known Member
- Posts
- 16,791
- Location
- Stonehouse, Scotland
Definitely looks like a handle off something. No threaded holes in the end?
Southernlandy
Active Member
- Posts
- 523
- Location
- Hampshire
Looks slightly like the handle from this http://www.amazon.co.uk/Bearing-Race-Seal-Driver-Set/dp/B000R9VVXO
joeyb
Member
- Posts
- 97
- Location
- Dundalk Co Louth Ireland
Looks more like an apprentice lathe exercise piece than a tool.
