What is this?

[Beaver]

This was in the cubby box of my new 90. Is a Land Rover part and if so, what is it used for?

 

[the_wolf]

It's an industrial strength dildo

 

[mick the builder]

Lining up wheel studs?

 

[bushwwacker]

Priest?

Fooking mahoosive urethral sond?

Apprentice piece?

PTO insert for a butt plug?

 

[s0ftmick]

It looks a bit on the big side but could be a timing pin?? What's the width?

 

[Beaver]

It looks a bit on the big side but could be a timing pin?? What's the width?

About 19mm at the thin end and 30mm at the fat bit.

 

[Beaver]

Priest?

quote]
I thought of using it as a priest but it's a bit heavy. It would cave the little trouty's head in.

 

[meego]

Clutch alignment tool ???? Is it long enough for that???

 

[Sutty]

It's for killing salmon and trout your right. My grandad had a few of them!

 

[The Mad Hat Man]

clutch alignment.

 

[meego]

Bugger carryin that for a priest. It would pull yer troosers doon.

 

[wattfield]

What's it made of, how heavy is it, and are there any marks on the ends?

 

[Beaver]

What's it made of, how heavy is it, and are there any marks on the ends?

No marks and it weighs 18oz. It's made of metal!

 

[wattfield]

No marks and it weighs 18oz. It's made of metal!

"Metal" covers a few different things, but the weight was the point!

Still don't know what it is, I was just curious. Heavy, aint it?

 

[Beaver]

I'm guessing it's not a Land Rover part then.

 

[the_wolf]

Definitely looks like a handle off something. No threaded holes in the end?

 

[Beaver]

Nope. When I bought it the mystery item was inthe chubby box with the locking wheel nut key.

 

[Southernlandy]

Looks slightly like the handle from this http://www.amazon.co.uk/Bearing-Race-Seal-Driver-Set/dp/B000R9VVXO

 

[joeyb]

Looks more like an apprentice lathe exercise piece than a tool.