robint
Well-Known Member
- Posts
- 7,057
What have you done to your Landie today.
- Thread starter madfrank
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Fur Trapper
Banned
- Posts
- 8,481
- Location
- international
Put wheels on fender.
And tomorrow:
Fitting the raptor dash and rear fog light i think.
Got a hurry on as im leaving for the states just after salisbury for most of the yearand i have a LOT of bits to fit before i go.
You get to Michigan give a shout
- Posts
- 8,543
- Location
- Tamworth, staffs.
Will do John.
The cheapest i found was £127.96 inc VAT. So rough maths makes that £524 ish for 4.
chunkymunky
New Member
- Posts
- 9,901
- Location
- worcestershire
Is that bronze green bgb? Same as mine but dunno code
colin132
New Member
- Posts
- 84
- Location
- West Lothian,Scotland
Put in a new fuel filter and a new parking brake warning switch.
- Posts
- 8,543
- Location
- Tamworth, staffs.
chunkymunky
New Member
- Posts
- 9,901
- Location
- worcestershire
Hmmm the mystery continues. Think i am gonna repray it.....green!
erm pass mate. ask me one on sport!
Is it epsom green???
looks like conniston green
chunkymunky
New Member
- Posts
- 9,901
- Location
- worcestershire
- Posts
- 8,543
- Location
- Tamworth, staffs.
That could be it.
I think mine looks the same colour as your 110 john.
I fink thats slightly darker than mine. Maybe wrong.
ratty
I'm not special I'm limited edition
- Posts
- 34,277
Took the rear pads out and sanded them down slightly to get rid of the glaze on them, hopefully that will stop the brake squeaking
If the squeal is still there, try chamfering off the leading edge of the pad.
I emptied another load of burnables out the back of mine and did the final measuring up before I start chopping the roof bars down to size.
buckshot
Well-Known Member
- Posts
- 9,841
- Location
- right yer!
aint you finished that job yet!?:doh:
buckshot
Well-Known Member
- Posts
- 9,841
- Location
- right yer!
made a start on fabricating a heavy duty plating for the rear cross member ready for the new nato hitch , need to take the plate into the engineering shop tomorrow where i been working and use their pillar drill to drill it out to take the bolts
ratty
I'm not special I'm limited edition
- Posts
- 34,277
- Posts
- 83,232
- Location
- Embasinga stocæ
Ordered a few more body panels.
Andy Land
Well-Known Member
- Posts
- 4,499
- Location
- ... en route to Cuckoosville.
Changed my gearbox oil and noticed the tranny box was leaking badly so need to investigate!
andlover
New Member
- Posts
- 265
- Location
- finland (here where santa lives)
on my td5: cleaned map,aap,maf and repaired the connection on boost control valve pirburg made, the brown wire was cutted so no wonder it wont work.....
