Littelwill
Well-Known Member
- Posts
- 3,065
- Location
- Lincolnshire
They look great Domino! going past ScrewFix tomorrow as well...
wet drivers floor
- Thread starter Ianwallace
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Ianwallace
Active Member
- Posts
- 288
- Location
- Calne Wiltshire
Decided to book a few days off to do this job myself. While the dash is apart is there anything else that needs to be replaced like blend motors as I would rather do everything now as I don't really want to take the dash apart again
- Posts
- 16,475
If your doing the full dash out jobbie....then yes do the blend motors too.....
Ianwallace
Active Member
- Posts
- 288
- Location
- Calne Wiltshire
How many motors are there
brianp38dse
Well-Known Member
- Posts
- 19,630
- Location
- heathrow
Three they come as a pre wired set.
Littelwill
Well-Known Member
- Posts
- 3,065
- Location
- Lincolnshire
Don't plug them in and switch ignition on until they are fitted. 
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
You don't have to take the dash out to do the O rings. If your blend motors are working, why make the job harder?
Ianwallace
Active Member
- Posts
- 288
- Location
- Calne Wiltshire
I'm going to to the matrix as well
Datatek
Well-Known Member
- Posts
- 44,069
- Location
- Near Poitiers SW France
Matrix rarely fails,why change it?
Ianwallace
Active Member
- Posts
- 288
- Location
- Calne Wiltshire
Just looked on how to take the dash apart
Stuff that I'm going in from the side chaps
Stuff that I'm going in from the side chaps
- Posts
- 16,475
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
Someone took the radio out to access the bolt, worth a look at if you have a problem getting it out.
Ianwallace
Active Member
- Posts
- 288
- Location
- Calne Wiltshire
I can't take the radio out I need to listen to something
- Posts
- 16,475
Never do work on a Range Rover with the battery connected...even if it seems a simple job....once short from a dropped tool or chaffed wire...and you are in a world of hurt!....search for Neo2's thread...one of the longest in LZ history!!
Ianwallace
Active Member
- Posts
- 288
- Location
- Calne Wiltshire
Your going to tell me next I can't use the kettle
I've just read that entire thread from start to finish.
Bit ****ed off on everyone elses behalf to find he then went and sold the damn thing!
