Theseus's Land Rover

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

solvista

Member
Posts
95
Location
Vigo, Galicia, Spain
So, I have a Land Rover. I replace the brake drums because they are worn. Is it still the same Land Rover?

Now and then other parts need to be replaced, so I replace them. At what stage does the Landy cease to be the same Landy? Does it ever cease to be the same one?

I replace the chassis, the bulk head, the body panels... in fact, over the course of a couple of decades, I replace every part of the Land Rover. Is it still the same Landy?

If it is, then what if I've kept all the parts from the original and put them all back together (because they were worn and tired but not completely unserviceable). Then I have two Land Rovers. Which one is the original? or are they the same Land Rover?
 
The question actually came up while (drunkenly) talking to a mate last night.

If we buy an old series, and then completely construct a new landy from a galv chassis, using 100% new parts, but use the old chassis number, can we get awsy with it? Essentially building a brand new series 3
 
Dont they have a points system whereby when you change so many parts you have to have it tested and put a "Q" reg plate on it?
 
there is a points system, but iirc replacing with the right parts "like for like" is allowed e.g a refurbed axle for a worn out one, but solvista is in spain so there may be different rules out there
 
I'm not sure about the rules here, but my point, really, is: Who would know? If I change chassis, engine, gear box, and drive chain, it'd be the same truck. But I'd still have the old chassis etc. that I could rebuild upon. Therefore making that one the original truck, no?
 
you could have the new one as your daily drive and keep the "original" one for shows :D

I have often considered buying an '82 in vgc swapping the bulkhead plates etc with my tax free and tired old 72 and scrapping the old 72 as the 82 :D

oh the bit where the number was stamped fell off mate :D
 
It's a valid idea, in theory. How do these fellas who swap a chassis over go about it? If you buy a new galvanised chassis and bulkhead, they won't have any stamps or plates on them, will they...

up until recently Richards would stamp your new chassis with your number - for a charge iirc - but apparently they are no longer allowed to do that
 
So, you drive around with no chassis number?

The doppelganger plan looks better all the time

you have to have a number but a series has a bolt on plate with your chassis number on the bulkhead so in theory they could just be swapped and the chassis stamp ground off, so if the later one was put on a new galv chassis it would be hard to tell. I an sure some expert could tell by looking at axle/gearbox numbers etc and over here you could be in trouble for masquerading a later vehicle as tax free if they could make it stick. I am sure it will have been done by some
 
Back
Top