TD6 Analogue Clock has gone mad !

The dash clock in the centre console is constantly spinning round at the speed it usually spins whilst setting the correct time.

All was well on way home until I removed ignition key then the clock "went mad" and now I can only stop it spinning (key in or out) by removing Fuse 13 - this fuse is also powering the ABS/DSC so obviously have left it removed tonight so no battery drain or worse the analogue clock short circuits !

Is there a way to reset/reboot the in dash unit as I understand the Analogue clock is controlled by the in-dash Radio TV/Sat Nav unit ?

I have removed both the connectors on the TV unit in the boot area but that had no effect on the clock spinning.

I also removed the Nav CD and reset that but no difference

Anyone else ever had the same problem ? (nothing when I searched)

Who was it that said the L322 is a money pit !

:hysterically_laughi:hysterically_laughi Time flys

Datatek said:

:hysterically_laughi:hysterically_laughi Time flys

Click to expand...

One Cough

Two Cough

Three Cough

*add the next cough here*



:mooning:

Disconnect battery for 10 mins

2.0_hippo said:

Disconnect battery for 10 mins

Click to expand...

How can I measure 10 minutes if the battery is disconnected and the clock stops ?

RS2000CUSTOM said:

How can I measure 10 minutes if the battery is disconnected and the clock stops ?

Click to expand...

Count to ten , you know one elephant, two elephant , three elephant and so on until ten elephant. Then do it again, and again, and again and again and again and again ..................................................................... you get the idea :hysterically_laughi :hysterically_laughi :hysterically_laughi

RS2000CUSTOM said:

How can I measure 10 minutes if the battery is disconnected and the clock stops ?

Click to expand...

got a bloody watch aint ya?

or tell the mrs to to get ready to go out.

sorry thats 2 hours

Done nothing else but replaced fuse 13 this morning

Clock began spinning again but stopped at 12:00

I then reset the time in the dash display

Clock spun to the correct time and is fine now !

Due to fuse 13 feeding parts of ABS/DSC/AES I have had to clear loads of Can Bus Error codes in all systems

Been for a 5 mile drive ALL GOOD :bounce:

Till next time - lol