Tailgate lower plastic moulding removal?

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

TD4_4x4

Active Member
Posts
283
Location
North Yorkshire, UK
Hi.

RE: MK1 Freelander (facelift 2004 on):

This is probably an unanswered question as unless you want to repaint your tailgate door/trim, no one would do this. On the part of the vehicle (see photo) I'm trying to remove the plastic trim panel, but can't work out how to as...

If you remove the door card and take a peek inside the bowels of the metal door, you'll see some yellow trim studs so I'm guessing it's these that hold the plastic external panel on. Squeezing them has no effect as they're too strong. Squeezing them harder with pliers crushes the plastic but then they're still too stiff to push outwards.

So my question was, do you think it's OK to cut them off with a hacksaw blade? (I don't know if the yellow studs can be replaced),and can't find any photos online to see what the back looks like, as I don't know the part number.

Any idea would be welcome, thank you.
 

Attachments

  • Freelander_Facelift_2_part_trim_panel.jpg
    Freelander_Facelift_2_part_trim_panel.jpg
    41.6 KB · Views: 164
Unless your changing the colour why take it off? I resprayed my boot door but just masked the trim off, unless you look at it very closely you'd never know.
 
I'm wanting to colour code the plastic panel, and am doing a few little mods that require a re-spray to body colour. Your idea is sensible thank you, but I've spent so long modifiying it, I want to finish the last bits off how I wanted it. I think I'll cut the plastic bits out and hope for the best.
 
The trim should just pull off. The yellow fittings in the door are one part of a two part fixing. The yellow part stays in the door. The trim clips into the yellow part. So a controlled pull is needed to pop the trim retaining "buttons" out of the yellow part.
 
The trim should just pull off. The yellow fittings in the door are one part of a two part fixing. The yellow part stays in the door. The trim clips into the yellow part. So a controlled pull is needed to pop the trim retaining "buttons" out of the yellow part.

Thanks for the tip, I won't do it myself as I don't have the strength but I'll find someone I'm sure.
 
Back
Top