Suspension fault

N

Nightsman32

Active Member

Posts

117

Location

South wales valleys

• May 6, 2020

• #1

Hi guys

My suspension is is access mode so very low down and uncomfortable ro drive it says suspension will rise when system cooled
Its been saying it for hours so definatly be cool by now.
Is there anything i can do to get ir back to normal height i cant drive it on access mode its very bouncy
Thanks guys

 

brianp38dse

Well-Known Member

Posts

20,094

Location

heathrow

• May 6, 2020

• #2

It probably means you have a leak in the system and the pumps overheated trying to keep it fed Diag probably needed to clear fault after leak fix.

 

N

Nightsman32

Active Member

Posts

117

Location

South wales valleys

• May 6, 2020

• #3

Is there any way to get it back to normal height. Never noticed a leak before and if left it dont drop at all.
Thanks

 

Datatek

Well-Known Member

Posts

45,023

Location

Near Poitiers SW France

• May 7, 2020

• #4

What car is it?

 

N

Nightsman32

Active Member

Posts

117

Location

South wales valleys

• May 8, 2020

• #5

Datatek said:

What car is it?

Click to expand...

2008 range rover sport 2.7 hse
AMK pump fitted
Thanks

 

N

Nightsman32

Active Member

Posts

117

Location

South wales valleys

• May 8, 2020

• #6

2008 range rover sport 2.7 hse
AMK pump fitted
Thanks
All i want is to temporary get it to normal height so i can use it until new pump gets delivered. Thanks guys

 

M

Mugsnstuff

New Member

Posts

2

Location

liverpool

• May 9, 2020

• #7

You may well have this fixed now, but if not, here is a trick I learnt with experience !!!

Leave a car door open and run the car, this will allow the compressor to fill the resevoir tank, leave it a couple of minutes to make sure (in case you have a week compressor) then shut the door, the system seems to then allow a flurry of air to most needed airbag (path of least resistance, ie low pressure) and 'should' raise the car. If you have a split in an awkward place, if your lucky, it may raise enough to get past the leaking part and may hold, sometimes when these things go too low is when they cant get back up! A bit like us old folk lol ! I use to do this to change leaking airbags as sometimes it would lay so flat to the ground I could not get a jack under it !

It may help, hope so !

 

gstuart

D3 Grandad

Full Member

Posts

30,790

Location

Kent

• May 9, 2020

• #8

Hi

that’s really interesting , in the D3 as soon as the door is open it completely disables the suspension

assume the RRS has a different software program

always good to learn new things

 

N

Nightsman32

Active Member

Posts

117

Location

South wales valleys

• May 10, 2020

• #9

My suspension wont do nothing with the doors open if i remember right when it was working properly it would tell me.to close the door before it would allow the suspension to work

 

N

Nightsman32

Active Member

Posts

117

Location

South wales valleys

• May 10, 2020

• #10

Mugsnstuff said:

You may well have this fixed now, but if not, here is a trick I learnt with experience !!!

Leave a car door open and run the car, this will allow the compressor to fill the resevoir tank, leave it a couple of minutes to make sure (in case you have a week compressor) then shut the door, the system seems to then allow a flurry of air to most needed airbag (path of least resistance, ie low pressure) and 'should' raise the car. If you have a split in an awkward place, if your lucky, it may raise enough to get past the leaking part and may hold, sometimes when these things go too low is when they cant get back up! A bit like us old folk lol ! I use to do this to change leaking airbags as sometimes it would lay so flat to the ground I could not get a jack under it !

It may help, hope so !

Click to expand...

Tried that and didnt work. The pump is making a very very quiet buzzing hissing noise so id say its definatly given up.