- Posts
- 83,230
- Location
- Embasinga stocæ
any of you folks know what type of material is used as a gasket between a supercharger and inlet adapter?
is it a silicone type or paper? or summat else?
is it a silicone type or paper? or summat else?
supercharger gasket
- Thread starter The Mad Hat Man
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 66,506
- Location
- The Wooly Witch
If you need a gasket for a Eaton M45 just go to a friendly BMW dealer and buy one, its steel with sealant already on it.
and it's cheap enough not to make your own...
- Posts
- 83,230
- Location
- Embasinga stocæ
it aint an m45.
its to fit on a lexus lump.
its to fit on a lexus lump.
- Posts
- 66,506
- Location
- The Wooly Witch
Hot side?
- Posts
- 83,230
- Location
- Embasinga stocæ
i would think so - inlet manifold adaper.
- Posts
- 66,506
- Location
- The Wooly Witch
Would have to be a composite then, will a OEM not fit?
- Posts
- 83,230
- Location
- Embasinga stocæ
not sure - will have to get kwakkers to post - its his motor.
- Posts
- 66,506
- Location
- The Wooly Witch
If it's 'near', then a trim with a dremel and a smear of HT sealant should do, did it come as a SC kit with the adaptor?
Kwakka666
Member
- Posts
- 26
- Location
- Basingstoke, HANTS
- Posts
- 66,506
- Location
- The Wooly Witch
