chainsaw
Active Member
- Posts
- 132
- Location
- Fermanagh, Northern Ireland
Will a SIII bumber fit a 1990 def90 without mod?
SIII Bumper
- Thread starter chainsaw
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
blue beasty
Leaks an prone to bits dropping off
- Posts
- 61,280
- Location
- Gloucestercotshirewolds
reckon a 90's is slightly longer.......or wider pending on how you look at it, but fitments the same
chainsaw
Active Member
- Posts
- 132
- Location
- Fermanagh, Northern Ireland
Can't be much in it lengthwise, as long as the fitting to chassis is the same - just got offered a good straight one for nothing!
Shifty1962
Well-Known Member
- Posts
- 4,209
- Location
- The Winchester Club - Englandshire
So take it and see. If it dont fit offer it on here. What you got to loose?
chainsaw
Active Member
- Posts
- 132
- Location
- Fermanagh, Northern Ireland
Yes, your right 2" shorter - an inch each side is barely noticeable.
blue beasty
Leaks an prone to bits dropping off
- Posts
- 61,280
- Location
- Gloucestercotshirewolds
chainsaw
Active Member
- Posts
- 132
- Location
- Fermanagh, Northern Ireland
:clap2:
Yes good job - I didn't realise that it would be shorter, my main concern was that the fitting is the same - thanks.
Yes good job - I didn't realise that it would be shorter, my main concern was that the fitting is the same - thanks.
chainsaw
Active Member
- Posts
- 132
- Location
- Fermanagh, Northern Ireland
Just for the record - the mounting holes are spot on and fits perfectly but it sits out from the front panel about 2" more than the original and thats noticeable. Easily fixed with an angle grinder and repositioning mounting holes accordingly. The difference in length is not that noticeable.
