sheared wheel nut

Thread starter joe soap
Start date Jan 29, 2017

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

joe soap

Active Member

Jan 29, 2017

#1

hello-- sheared wheel nut on back after replacing wheel -can stud be replaced with out removing hub---thanks

Tony e

Well-Known Member

Jan 29, 2017

#2

Only if yer a good welder

Blackburn

Well-Known Member

Jan 29, 2017

#3

Depends what model landrover as series 2 are tapped /thread into hub.
Later ones are pull in studs.

joe soap

Active Member

Jan 29, 2017

#4

Blackburn said:
Depends what model landrover as series 2 are tapped /thread into hub.
Later ones are pull in studs.

thanks- if it is the pull in stud is there enough room behind to put in stud[[1971 2a swb]

Blackburn

Well-Known Member

Jan 29, 2017

#5

Your better off taking the hub off as you could damage the wheel bearings punching the old one out.

You must log in or register to reply here.

Similar threads

Abs speed sensor

Replies: 1

Views: 271

Replies: 18

Views: 845

Half shaft nut retaining clips

Replies: 8

Views: 624

Broken engine coolant tap

Replies: 4

Views: 206

Sunday at 19:36

Stripped Wheel Stud L322

2

Replies: 27

Views: 1K

Share:

Reddit Pinterest Tumblr WhatsApp Email Link

Welcome To LandyZone, the Land Rover Forums!

Here at LandyZone we have plenty of very knowledgable members so if you have any questions about your Land Rover or just want to connect with other Landy owners, you're in the right place.

Registering is free and easy just click here, we hope to see you on the forums soon!