Rear recovery

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
harlequin

harlequin

New Member
Posts
176
Hi all. What in your opinion is the best item to fit for rear recovery.

I have no rear towing eyes to change for jate rings as they have been welded up when fitting new rear cross member.

I dont have or want a towing bracket.

All advice gratefully recieved
 
Well you could do worse than a towball directly in your xmember.
if you dont want a tow point. and refuse to fit jates then your asking us how do you fit somthing you refuse to nor want??? confused?
 
Not saying I dont want jates. Am saying I do not have the holes for jates as rear crossmember and short legs have been replaced and looks like recovery point holes have been welded up.

Is cross member strong enough to take a towball just for recovery
 
depends on how hard recovery is but i would weld plate across rear cross member to reach as far as chassis legs ,as the ones ive seen without have cross member bent
 
If It was myown motor I would drill holes for jate rings through the double thickness of xmember and old chassis then weld in tubes grind weld flush and then use jates.

Xmember can do similar drill two holes insert tubes weld them in grind the surface weld flush use spreader plates 6mm plate both sides and bolt up. If the xmember has a crush plate or wavey plate internally already then you shouldn't need the tubes but I would fit them meself for peace of mind
 
Try this Gary.

Defender2 - View topic - Recovery points

Youve seen what i have? dixon bate tow ball and bar, mine is bolted into the rear cross member with a 6mm thick steel plate behind and tubes between so it dosent bend the cross member.

I have seen the qtservices one on the link above though, very well made.
 
I would say Jate Rings all the way as you can then make a bridle up out of an 2mtr 10t strop and thus half the force put on each leg ;) same at the front.
 
BIG_GINGA_BEARD said:
Try this Gary.

Defender2 - View topic - Recovery points

Youve seen what i have? dixon bate tow ball and bar, mine is bolted into the rear cross member with a 6mm thick steel plate behind and tubes between so it dosent bend the cross member.

I have seen the qtservices one on the link above though, very well made.
Click to expand...

Same here. I then have two drop plates one with a tow pin/ball and the other with standard NATO pintle. I use the pintle fir recovery.
 
You must log in or register to reply here.

Similar threads

M
Side rail mounting repair
Replies
3
Views
530
dag019
dag019
P
Defender 90 LED lights
Replies
12
Views
623
Prankstaaa
P
V
Advice on bolt size
Replies
4
Views
873
Brown
Brown
dag019
Which replacement rear door
Replies
13
Views
1K
dag019
dag019
dag019
Rear door check strap
Replies
14
Views
1K
dag019
dag019
Back
Top