ramraider7
Member
- Posts
- 27
- Location
- Sandwich Kent
My rear door is scraping as it's closed, is there adjustment like on the front doors with shims or do I just get new hinges & if so wheres the best (cheapest) lol place to go
Disco 1 rear door dropped
- Thread starter ramraider7
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Interceptorxj
Well-Known Member
- Posts
- 1,723
- Location
- Bolton, Greater Manchester.
If the pins aren't worn take the top hinge off and stick it in a vice and use a big hammer to bend the hinge fork slightly to the right.
- Posts
- 9,105
- Location
- Roaming the UK on assignments
If you're going to the trouble of removing a worn part then you might as well spend the £30 and get a new one to replace it
http://www.land-rover-parts-shop.co... End Door&group=Rear End Door Hinge&year=1998
Interceptorxj
Well-Known Member
- Posts
- 1,723
- Location
- Bolton, Greater Manchester.
If you're going to the trouble of removing a worn part then you might as well spend the £30 and get a new one to replace it
Which is why I stated "if the pins AREN'T WORN"! Spending ZERO pounds is much better than spending £30 on an inferior replacement part.
- Posts
- 9,105
- Location
- Roaming the UK on assignments
No other reason that the door would drop is there? But even then, you can adjust the hinges in the door and on the door post to set the seal and the door gap
Interceptorxj
Well-Known Member
- Posts
- 1,723
- Location
- Bolton, Greater Manchester.
Mine got bent when I drove off without the door shut properly and it swung open, there was no side to side adjustment on the hinges. If it is just catching on the door shut side then either the pins are worn or the hinge is bent.
Similar threads
