Rear brake cylinder Freelander

sailorden · May 24, 2010

Hi

I am working on a freelander (year 2000).

The brake cylinders on the rear drum brakes were weeping so I decided to change the cylinders at the same time as I changed the brake shoes.

I cant get the brake cylinder mounting bolts out. I used an 8mm ring spanner and it just slips around. So before I round the bolt head off and add to my head ache, a simple question.

Are they a special size, type or what? Ive just soaked them with WD40 and retired back to my computer with my tail hanging low.

Any ideas anyone?

Please help a poor 1st timer

Sailorden

cremator · May 24, 2010

just done mine they are a 8mm ring spanner trouble is you got a steel bolt going into alloy give them a good tap that sometimes loosens them if not use plus gas or simular wd not that good or try 8mm socket

sailorden · May 24, 2010

ill give it a go. My 8mm ring just slips arround so maybe someone has had a go at them before and rounded them off (or maybe they have lost some of the head width due to rust).

Ill get a torch on it to warm things up a bit, and I suppose if that fails then cutting off the head would be the last option.

The other side looks ok so maybe that will be easier?

OldIrishWulf · May 25, 2010

I had the same happen to mine.I got it off by hammering on an open imperial spanner,not sure what size.You could try to batter on a 7mm.Get a few bolts ready to replace the knackered ones,and copper grease them for the next guy.

para1966 · May 25, 2010

Try and use an impact socket if you can as these are only 6 point not 12, and put everything back together with a smear of copper grease on all threads to prevent future seizing.

Mantamad · May 25, 2010

Sometimes bolts like this are just not worth the hassle - grind the head off then fit a new bolt with the replacement cylinder - so much easier in the long run

sailorden · May 27, 2010

Hi,

Thanks all for your suggestions. In the end I resorted to a cold chisel and a lump hammer and the bolt heads popped off like they were shot out of a cannon!

More dumm questions from me in the future I fear!

Thanks again!

joe27979 · Sep 18, 2011

hi chaps - resurecting an old thread here....what size bolts fir the rear wheel cylinders? I have a siezed bleed nipple so need to change the cylinder as a job lot - want to get some mounting bolts for the cylinder incase these are a biatch too!/ cheers

joe27979 · Sep 19, 2011

M6 x10mm Joe ;p

Rear brake cylinder Freelander

sailorden

New Member

cremator

New Member

sailorden

New Member

OldIrishWulf

Well-Known Member

para1966

New Member

Mantamad

New Member

sailorden

New Member

joe27979

Well-Known Member

joe27979

Well-Known Member

Similar threads