hi it have a 1995 rangerover and the key fob was fallin to pieces so replaced the buttons which was fine reprogrammed the keys to the jeep and all the doors locked unlocked etc it was fine untill i went to start it and it is now comming up with engine immobilised and now wont start the hand book is saying to use a four digit code that should b on a card i dont have prob been lost over the years any help would b appreciated as i cant drive it at all now!!thanks rolly :doh:
rangerover P38 2.5dse key programming
- Thread starter rolly0788
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
j the range
New Member
- Posts
- 3,927
- Location
- liverpool
you need your eka code, go to main steler and get it..
Irishrover
Well-Known Member
- Posts
- 5,317
- Location
- La Trimouille, Vienne, France
An introduction would be appropriate before diving in plus your LOCATION:frusty:
As J says, you can get it from the dealer
As J says, you can get it from the dealer
m444ty p
New Member
- Posts
- 56
- Location
- Clacton-On-Sea,Essex
Do the dealers charge for these codes?
j the range
New Member
- Posts
- 3,927
- Location
- liverpool
no free of charge, but you will need your log book..
kj200sx
New Member
- Posts
- 302
- Location
- northampton
and some id mate photo id bill etc etc. in your handbook is how to enter it and if you dont have one there is a thread on hre of how to do it i think if not give me a pm and will find out how to do it for you
rangiegal
New Member
- Posts
- 466
- Location
- Burton on Trent, East Midlands
Next time round sync the fob to your Rangie and not a jeep, you may have more success. No Range Rover will put up with being called a "jeep" as its quite offensive really!!!!
Similar threads
