Propshaft Refurb

Hi again,
so I've decided to refurb my propshaft by replacing the UJ's , the carrier bearings and the vcu and also the gaiter at least partly because it split and sort of came loose while we were removing the propshaft .
I 've ordered a new vcu , uj's x 3 , gaiter and a set of snap clip pliers .

Is there anything I should know or other bits I should order to make the process go as smoothly as possible?

Thanks

I think you're covered, although you might want a couple of the lock washers (TYF101050) too.

And search and watch the video on removing the prop joints from vcu splines. You'll need a long thin chisel and a large hammer!!