No Timing Belt

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

stefan7n

Active Member
Posts
108
Location
South East UK
So I called Land Rover Gatwick today to ask how much it would be for the timing belt and belts in that section of the car to be changed on a 2.0 litre XeDi 2000, W reg.

The lady rang and left a message saying that according to her computer my car has no timing belt!!!

I've confirmed on the Haynes manual and I was right! I do have one. As I suspected the valves don't just magically turn themselves in the correct sequence! to make the wheels turn.

Has anyone got a pic of that side of the engine or can someone tell me all the belts driven from the crankshaft, either directly or non-direct?

Regards,
Stefan.
 
Not sure about the xedi, but the petrol had a timing belt, and the td4 had a timing chain, which doesnt need to be replaced. You sure its not a chain shown for the xedi?
 
Timing Belt - Freelander 2000 XEDI

untitled.jpg
 
Last edited:
yep it has a timing belt, two in total. one for the camhsaft to crank and one for other end of crank above gearbox, does the diesel pump timing.

freelandercambelt.png
 
Sounds to me like the lady on service reception made a mistake on the vehicle model (probably used to dealing with TD4's rather than the older ones) but then the inclusion of a picture of the aux drive-belt routing is adding confusion to this discussion as it is a different thing altogether.
 
Sounds to me like the lady on service reception made a mistake on the vehicle model (probably used to dealing with TD4's rather than the older ones) but then the inclusion of a picture of the aux drive-belt routing is adding confusion to this discussion as it is a different thing altogether.

I have not dealt with my local dealers service reception for years (ever since they quoted me £700 for a Disco TD5 service:eek:) but at that time it seemed that an essential requirement for the job was to know feck all about vehicles:dizzy:
 
hi

may i ask where you get your images from please is there a link or can you buy the software please.

thanks guys

gary
 
hi

may i ask where you get your images from please is there a link or can you buy the software please.

thanks guys

gary
Its a soft ware package called autodata most smaller garages use it very usefull if you work on a number of different make's of car as i do. Quite expensive if you don't used it often, but you can get hooky discs..........apparrently;)
 
The trouble is your freelander is on a w reg

there are also early td4's on a w reg

you need to give them the VIN/chassis number as this relates to the manufactured vehicle not the letter on the plate

hope that helps
 
Back
Top