New 90 project startup!!

Boooh that sucks

Done the rear bearings, new disks and pads, cut off the anti roll bar mounts and tidied up a few bits and bobs. Brakes work far better now :-D

Getting the disks off the hubs was a bit of a joke but fbh prevailed

Passed the mot.... now taxed and insured too.... restoration show here i come baby!!!

Nice 1 - well done mate!!!

Daz

MrPDude said:

Passed the mot.... now taxed and insured too.... restoration show here i come baby!!!

Click to expand...

resrltoration show

Your going to enter a show with that gearbox????

No I'm just driving it there smart arse

Not bad for a "gearbox" need some cranked trailing arms though

Sweet pics dude

Cheers mate. The standard trailing arms really make a difference to articulation. Gotta get the new ones (or manually bend these ones) asap

Top job that buddy. Now you just need to give it a proper test at our Wales session on 9th to 11th November.

can i ask where you are its like a landrover jungle haha

You have done a good job keep up the hard work

I'm in Solihull mate.

Cheers for all the support lads. Been more than one occasion when I've wanted to sell it off as an un finished project.

Now that it's on the road, the real work can begin.. Starting with cleaning up the patchwork Frankenchassis

Done loads of work since the mot. Side steps/sliders/tree guards. Wing tops, Ghetto heater made from 12plate heat exchanger, high temp water pump, 120x240mm radiator with 2x 120mm fans. Various other bits and bobs. Reovery point on the rear, cb, new belt tensioner bearing. Chopped steering guard to allow room for drag link to move under axle articulation

Just a mass of pictures im afraid, i cba to sort em out. If you cant figure it out then oh well... Enjoy the shots