my poor unbalanced disco2

Far away from TestBooks I need to calibrate the right side Height Sensor of the rear suspension. Who could help me?
My Disco 2 Td5 needed a change of the right air suspesion bag, which I did. But also before that change the right side level of the car was 6-7 mm lower than the left side (at the normal (low) SLS- level). At the high SLS-level the difference is even more 10-11 mm lower at the right side than the left.
Is this a Height Sensor CALIBRATION problem? Could it be corrected/repaired without the TestBook ? Otherwise I must travel 2000km to Buenos Aires !
Saludos from South Bolivia,
Ton O.

Calibration without Testbook isn`t possible IMO
And 7mm is not too much difference.
But to get an easy OBD reader like Hawkeye or Nanocom is cheaper then the fuel for 2000km.

Ahaggar said:

Calibration without Testbook isn`t possible IMO
And 7mm is not too much difference.
But to get an easy OBD reader like Hawkeye or Nanocom is cheaper then the fuel for 2000km.

Click to expand...

Ahaggar, that is fine, thanks.
In the meanwhile I have the bag replaced by a used one, since or the original or OEM-parts are not available, or they charge you US$ 900,00 EACH (they say they are oficial LR-dealer !!) or the custom-people charge you an huge amount on imported ones, that makes the price comparable with the oficial-dealer price..... Only when you will go to Europe or the States one can obtain one at normal prices.
Thanks anyhow for your comments. The level difference between the left and right side sometimes is a little more and sometimes a little less than 8 mm. I belive it depends actually also on the (high) temperature of the climate here. I am not very much worried since your reaction. Thanks again.
Could you give me soem more details about that instrument which could replace, or used instead of the testbook?
regards,
Ton O.

The hawkeye does not set the ride height, only the Nanocom will set it, hawkeye will adjust it but can not set it to the BCU, have a look at Blackbox solutions in cyprus.