Limp mode after water ingress

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

shopereira

New Member
Posts
1
Hi guys,

I'm pretty new here, so forgive me for any mistakes. Long story short, I left my sunroof open on a very rainy day, and the console was pretty much under water. After cleaning everything, the only problem remaining was that the D position was always on (and Manual Mode wasn't working either). Well, out of the blue, it got into limp mode (picture attached). Here are the codes I'm getting as we speak:



---xxx---

L319 - LR3 2008 (Canada)

Vehicle scanned on 03-07-2025 10:59

Steering Angle



U0122-87 (2F) Lost communication with vehicle dynamics control module - Bus signal/message failure - missing a message

( on 11-01-2026 18:17:37 at 206776 km )

- Test Failed

- Test Failed This Monitoring Cycle

- Confirmed

- Test Failed Since Last Clear

Suspension



U0122-87 (AF) Lost communication with vehicle dynamics control module - Bus signal/message failure - missing a message

( on 11-01-2026 18:17:47 at 206776 km )

- Test Failed

- Test Failed This Monitoring Cycle

- Confirmed

- Test Failed Since Last Clear

- MIL Requested

U0100-87 (2F) Lost communication with engine control module/powertrain control module 'A' - Bus signal/message failure - missing a message

( on 11-01-2026 18:17:51 at 206776 km )

- Test Failed

- Test Failed This Monitoring Cycle

- Confirmed

- Test Failed Since Last Clear

U0101-87 (2F) Lost communication with transmission control module - Bus signal/message failure - missing a message

( on 11-01-2026 18:17:51 at 206776 km )

- Test Failed

- Test Failed This Monitoring Cycle

- Confirmed

- Test Failed Since Last Clear

U0128-87 (2F) Lost communication with parking brake control module - Bus signal/message failure - missing a message

( on 11-01-2026 18:17:51 at 206776 km )

- Test Failed

- Test Failed This Monitoring Cycle

- Confirmed

- Test Failed Since Last Clear

U0102-87 (2F) Lost communication with transfer case control module - Bus signal/message failure - missing a message

( on 11-01-2026 18:17:51 at 206776 km )

- Test Failed

- Test Failed This Monitoring Cycle

- Confirmed

- Test Failed Since Last Clear

U1A13-87 (2F) Lost communication with all terrain control module - Bus signal/message failure - missing a message

( on 11-01-2026 18:17:51 at 206776 km )

- Test Failed

- Test Failed This Monitoring Cycle

- Confirmed

- Test Failed Since Last Clear



---xxx---

I was reading a few posts, and people talk about the Turbo Actuator getting stuck, but I confess I wasn't able to find it to give it a try. Any help is much appreciated.

thx again,





Sergio
 

Attachments

  • 5132012476341268259.jpg
    5132012476341268259.jpg
    145.7 KB · Views: 8
Back
Top