mark-d
Well-Known Member
- Posts
- 1,107
- Location
- Netherlands
im taking out my engine tomorrow but unsure how to lift it, the haynes book says to take out a head bolt and make a bracket up to lift it there but i dont like that idear, any better idears?
lifting it out
- Thread starter mark-d
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Sirus
Your all Banned except me
- Posts
- 22,196
- Location
- The Country of Black
I would use the engine lift points
Sirus
Your all Banned except me
- Posts
- 22,196
- Location
- The Country of Black
One on the front one on the back
bustersbus
Well-Known Member
- Posts
- 13,755
- Location
- Near Dumfries, Scotland
Aye like Sirus says
Thur's one at the front just to right of the water pump and one at the back near where the breather pipes are.
Thur's one at the front just to right of the water pump and one at the back near where the breather pipes are.
mark-d
Well-Known Member
- Posts
- 1,107
- Location
- Netherlands
thanks i used a long strop as there isnt a lifting point at the rear of the 200tdi only the front
Sirus
Your all Banned except me
- Posts
- 22,196
- Location
- The Country of Black
There is if you put one on or use a bolt
Sirus
Your all Banned except me
- Posts
- 22,196
- Location
- The Country of Black
Pikey
Dummy Ejection Facilitator..
- Posts
- 47,185
- Location
- in Baron Wet Bum's Slave pit..
I has a huge stack of 1tonne swl round slings, from the plumbers merchants. They is used to deliver the copper pipes etc, but they is disposable and are left behind by the truck drivers.
bustersbus
Well-Known Member
- Posts
- 13,755
- Location
- Near Dumfries, Scotland
Sirus
Your all Banned except me
- Posts
- 22,196
- Location
- The Country of Black
Theres one on mine too and 3 in me tool chest too
bustersbus
Well-Known Member
- Posts
- 13,755
- Location
- Near Dumfries, Scotland
lerk
New Member
- Posts
- 1,763
- Location
- Creswell, Derbyshire UK
My mates 90 300 only has one on the front, cos the lazy bastid that did his HG didn't put it back on for him... thoughtfully left it on top of his heater box for him instead!
hughesy
Well-Known Member
- Posts
- 4,200
- Location
- Isle of Anglesey
Some seem to have one at the front, some have both and occasionally you see one without any. I got meself a couple of ebay for about a fiver and just pop em on when I need to. The head bolt at the back and the front bolts to the head by the thermostat housing but you could use one of the head bolts just the same.
mark-d
Well-Known Member
- Posts
- 1,107
- Location
- Netherlands
Sirus
Your all Banned except me
- Posts
- 22,196
- Location
- The Country of Black
nope the holes are there for the bracket....some fookers nicked the bracket
90truckcab
Well-Known Member
- Posts
- 4,739
- Location
- staffordshire
straps, 3" wide ratchet straps, ropes, chains, used them all, yer can do it with just about anythin, am sure thers ment to be a bracket there
sypher
Well-Known Member
- Posts
- 1,997
- Location
- Forest of dean
Same here no lifting eyes on the 200 I took out today , just used straps slung around the block front and back .
