hello all problem with my 97 p38 dse immobiliser on; eka code ignored when entered with key ; central locking inop unable to gain accsess to bmce with my faultmate (single vehicle chassis no one for this car as i have used it before to disable immobiliser) but the thing is well and truley immobilised ,have mannaged to get engine cranking by jumping a wire from c257 pin 6 to c113 pin2 on bmce.I prusme the bcme is shot is there any way to by pass the the engine ecu immobiliser any help most appriciated.
imobiliser problem
- Thread starter esprig
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
gfromleeds
Well-Known Member
- Posts
- 2,234
- Location
- leeds. westyorkshire, uk
In short no!!!
New/used becm
New/used becm
Datatek
Well-Known Member
- Posts
- 44,134
- Location
- Near Poitiers SW France
If you think it's the BECM, contact rick the pick, on here. More likely it's not the BECM, fuse box, door locks, RF receiver, loss of sync all spring to mind.
P38guy
New Member
- Posts
- 308
Rick-the-Pick
Active Member
- Posts
- 782
- Location
- Hove, Sussex.
Did you say that you disabled the Passive immobilser?
Try the eka code with the drivers door open. When you turn the key to the left, push the inner door lock down hard. Turn the key to the right & pull the inner lock up.
If this method fails then get back to me.
Try the eka code with the drivers door open. When you turn the key to the left, push the inner door lock down hard. Turn the key to the right & pull the inner lock up.
If this method fails then get back to me.
Datatek
Well-Known Member
- Posts
- 44,134
- Location
- Near Poitiers SW France
You can enter the EKA code with a Faultmate
You can enter the EKA code with a Faultmate
Unable to access becm with faultmate as reading on laptop screen says becm in alarmed state use disarm & try again. Disarm feature not being read by becm so unable to access settings/information screen
Regards Ed
JohnP38
Active Member
- Posts
- 619
- Location
- Alton Hampshire UK/Cape Town SA
Sounds as if the BBS Sm035 module is needed to unlock and reset BECM.
Contact Rick ,he is the man to do that.
Contact Rick ,he is the man to do that.
Datatek
Well-Known Member
- Posts
- 44,134
- Location
- Near Poitiers SW France
The BECM has locked out, either buy the sm035 module for your Faultmate or send the BECM to rick the pick
ok thanks for your help will try and get a sm035 module and will let you know how i get onThe BECM has locked out, either buy the sm035 module for your Faultmate or send the BECM to rick the pick
regards Ed
just priced up sm035 module bloody hell think iwill contact rick instead
Last edited:
