HRW not working, advice plse

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
S

scotty57

Member
Posts
59
Hi,
I have just bought a 55 plate XEi as a 2nd car and the only fault I have found so far is the HRW does not work.

The light comes on with the switch, rear door is shut and the window is fully up. I'm going to check fuse first,then relay (is it behind fuse box ?) and then take the trim off the door and check the contacts. Is that the right approach or is there anything else I should look for ?
 
scotty57 said:
Hi,
I have just bought a 55 plate XEi as a 2nd car and the only fault I have found so far is the HRW does not work.

The light comes on with the switch, rear door is shut and the window is fully up. I'm going to check fuse first,then relay (is it behind fuse box ?) and then take the trim off the door and check the contacts. Is that the right approach or is there anything else I should look for ?
Click to expand...

Introduce Yourself - Land Rover Zone

and

:search:

UK Based Land Rover Forum, Land Rover Gallery and Land Rover Links. - Search Results for heated rear window not working

Simple really.
 
The tag can come off the window and or the wiring could be unplugged the window element could be damaged, the wiring from body into the door could be damaged, the control unit could be defective, a sensor could have failed, could be a fuse could be a relay.

But as you are asking the question in the way you are I would guess you have some idea of things...... So get on with it!
 
Checked the contacts on the glass and they are good and checked the wiring to the point it goes into the car body. Fuse is good and the switch appears to be ok.

Just stuck on which relay to check and I'm new to Freelanders so how do I check the control unit ?
 
Last edited:
the relay is No 2 interior fuse box

is there power across the terminals

any scratches in the element on the window - good luck
 
Brack - do you mean the heated rear window terminals ? I'm assuming I need to check those from the inside with the rear door shut and switch on?
It's a 5 door.

thanks guys
 
Last edited:
If theres power at the wires then take the glass out and inspect for damaged element - theres a big expanse of it from the soldered contacts up to the start of the grid - mine was all patchy and so i bought a better window.
 
Update : Checked voltage and I'm getting 14v at the screen terminal. I then checked each filament and I have 4 that appear to have a break in them (voltage above and nothing below). They are not really breaks but look worn so I'm guessing they rub as the window goes up and down. I'll try some of the paint on solder repair but if that fails I'll replace the glass unit
Thanks for the advice.
 
You must log in or register to reply here.

Similar threads

E
Freelander 1 Free lander 1 td4 thinking of buying one again.
Replies
7
Views
730
emjxl19
E
M
FL2 trouble starting - glow plugs recently replaced no light on dash
Replies
3
Views
1K
Nodge68
Nodge68
M
Rear Tailgate on landrover disc 3 2008 TDV6 will not open
Replies
2
Views
285
Moggytom
M
Montyjohn
P38A Passenger electric window not working
Replies
6
Views
969
Datatek
Datatek
P
Bizarre electrical fault!
Replies
3
Views
831
Nodge68
Nodge68
Back
Top