Help

billybuilder · Jul 14, 2009

Just bought a P38 reg Jan 1997 4.6. Lovely thing a few problems I am gradually sorting out. Came with one key fob which I thought was a bit sluggish - being smart i replaced the batteries even i can do that !! Now it does not work remotely and the engine is immobilished - Have tried all sorts of permutations including using the EKA thingy no luck. So it sits there saving on fuel but still dripping oil OH that is the other thing I need to sort out >>>>any suggestions please?

j the range · Jul 14, 2009

i had this when you press remote does the red light come on? if it does resinck put it in door press lock keep pressed and turn it

billybuilder · Jul 14, 2009

j the range said:
i had this when you press remote does the red light come on? if it does resinck put it in door press lock keep pressed and turn it

No red light!

nathan5346 · Jul 14, 2009

check the battery/terminals you need the light to come on b4 u do anythin else

Nidjet · Jul 14, 2009

Silly question I know, but the batts are in the right way up arn't they?

billybuilder · Jul 14, 2009

Thanks guys batterys could not have been seated properly took them out put them back and it works fine. Paranoid about electrical problems now for that oil leak!

Nidjet · Jul 14, 2009

Where's it coming from?

billybuilder · Jul 14, 2009

mid vehicle somewhere rear of engine it had a new oil cooler 4 months ago

gavbriggs · Jul 14, 2009

get under it and give it a good wipe down, then get someone to rev it while you look see where the leak is but i'm guessing rear crank seal or sump gasket!

billybuilder · Jul 15, 2009

Thanks Gav - not too serious then I hope

Help

billybuilder

New Member

j the range

New Member

billybuilder

New Member

nathan5346

Well-Known Member

Nidjet

Active Member

billybuilder

New Member

Nidjet

Active Member

billybuilder

New Member

gavbriggs

Well-Known Member

billybuilder

New Member

Similar threads