Help....! Tool needed...!

Anyone got a front hub alignment tool i could hire/buy/borrow/steal....! in exchange for beer tokens....

cut a long story short some pillock decided that they needed to loosen off the adjustable bottom front ball joint on my P38 and now i have gearbox fluid pouring out of the oil seal on the front axle.....!

just got off the phone from hunters RR in king's lynn and i think i spoke to the brother of the aforementioned pillock who was not willing to go and look for the specialist tool that has not been used in years...which i was willing to hire off them and told that i was wasting my time asking as they would be able to make any money out of me....yes really did say that....!!

so i need a "LRT 54 006"

if anyone has one or knows where i can get one that would be smashing....!!

Nick

Notice of intention of litigation and MCOL

sorry you lost me....?

Nickffc said:

Anyone got a front hub alignment tool i could hire/buy/borrow/steal....! in exchange for beer tokens....

cut a long story short some pillock decided that they needed to loosen off the adjustable bottom front ball joint on my P38 and now i have gearbox fluid pouring out of the oil seal on the front axle.....!

just got off the phone from hunters RR in king's lynn and i think i spoke to the brother of the aforementioned pillock who was not willing to go and look for the specialist tool that has not been used in years...which i was willing to hire off them and told that i was wasting my time asking as they would be able to make any money out of me....yes really did say that....!!

so i need a "LRT 54 006"

if anyone has one or knows where i can get one that would be smashing....!!

Nick

Click to expand...

As Fanny said notice of intended litigation to the pillock who loosened the joint
Not sure how you get gearbox oil out of the axle though

hahaha did i say gearbox oil.....doh....!:der:

whats the MCOL bit then....?

Nickffc said:

whats the MCOL bit then....?

Click to expand...

Money Claim Online.

When I did mine,I didn't use any special tools,there is a big washer connected to your drive shaft just centralise that within the axle case,should only be few mm either side ,can't go far off ,the oil seal behind is very flexable,wouldn't think it would leak from there unless way too much oil in it,or seal is damaged