TaDa
Active Member
- Posts
- 432
- Location
- Barnstaple or thereabouts
Hi!
Some swine nicked one of the fog light bezels off the front of my disco.
I have a pretty shrewd idea who it was but no way of proving it.
Anyway, I bought a new one and painted it up and then went out to put it in.
I realise I probably didn't prepre for this job very well :doh:
So when I offered it up I realised that the little plastic bits that fit through all the holes in the bumper need to be melted back to hold the bezel in place
At least I now know that the bezel did not fall out easily - someone was involved
I don't really want to shell out for an expensive tool just for this one-off job.
Is there a special technique for melting this plastic bits and fixing the bezel in place?
Cheers
Some swine nicked one of the fog light bezels off the front of my disco.
I have a pretty shrewd idea who it was but no way of proving it.
Anyway, I bought a new one and painted it up and then went out to put it in.
I realise I probably didn't prepre for this job very well :doh:
So when I offered it up I realised that the little plastic bits that fit through all the holes in the bumper need to be melted back to hold the bezel in place
At least I now know that the bezel did not fall out easily - someone was involved
I don't really want to shell out for an expensive tool just for this one-off job.
Is there a special technique for melting this plastic bits and fixing the bezel in place?
Cheers
