urena
Well-Known Member
- Posts
- 1,353
- Location
- Middle earth
i pretty sure some ones put a 2 and a quater head on this 2.5 derv sherpa lump:lalala: are the head gastket set the same???
engine
- Thread starter urena
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
theyd all fit as bores dont change only stroke of piston
urena
Well-Known Member
- Posts
- 1,353
- Location
- Middle earth
thought so
urena
Well-Known Member
- Posts
- 1,353
- Location
- Middle earth
im rebuilding a 2.5na derv whats the torq settings for injectors rocker gear and head bolts and glow plugs and sequance for head bolts
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
have a look in here ,head bolts are 95 lbsft or 130nm tighten center out
http://www.landroverweb.com/Pdf-files/Manuals/Defender-90-110-workshop-maunual-1.pdf
http://www.landroverweb.com/Pdf-files/Manuals/Defender-90-110-workshop-maunual-1.pdf
urena
Well-Known Member
- Posts
- 1,353
- Location
- Middle earth
just need injectors to head setting torq
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
you can just tighten them up evenly ,but 20lbft wouldnt be far away
urena
Well-Known Member
- Posts
- 1,353
- Location
- Middle earth
trouble bought head set no ####in markins on it need to no does the renforsing
for the hot spots face the block or head
for the hot spots face the block or head
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
metal to hot spot (head)
urena
Well-Known Member
- Posts
- 1,353
- Location
- Middle earth
thanks
urena
Well-Known Member
- Posts
- 1,353
- Location
- Middle earth
had it upside down good job i never done bolts up lol
urena
Well-Known Member
- Posts
- 1,353
- Location
- Middle earth
hi whats the valve settings hot + cold 25na please
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
10 thou
urena
Well-Known Member
- Posts
- 1,353
- Location
- Middle earth
in and exaust
urena
Well-Known Member
- Posts
- 1,353
- Location
- Middle earth
valves hot cold 25mm
25mm is a bit too much!
I'd be inclined to go for either 10 thou or 0.25mm
Dunno, 25mm would do wonders for the fuel economy.
zeaphod
Well-Known Member
- Posts
- 3,103
- Location
- Belfast, Norn Iron
The muppets who I mistook for mechanics set a few of mine at over 10mm - it still ran!
Oh yeah, also left the injector pump hanging by one nut and ruined the crankshaft seal.
DIY is the only way!
Oh yeah, also left the injector pump hanging by one nut and ruined the crankshaft seal.
DIY is the only way!
