reddevil2010
New Member
- Posts
- 23
Hi guys will a engine out of BMW fit its still a 2.5 TD Auto will it go into my P38 and does the BECM need redoing if the engine does fit ?regards Jeff.
Engine
- Thread starter reddevil2010
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Greenrover
Member
- Posts
- 34
- Location
- North Wales
Yes, if it is an M51. You will not need to touch the BECM. the only slightly tricky bit is swapping the top of the FIP. If you need any advice pm me I did the same swap last week. Another guy on here Tonyyzf was very helpful.
reddevil2010
New Member
- Posts
- 23
Thank you for that Greenrover
Greenrover
Member
- Posts
- 34
- Location
- North Wales
Yes, That simple.
You have to keep the BMW pump body because the RR pump will not fit the 5 series M51 engine. Then all you need to do is just be very careful fitting the EDC (top half of the pump) and be patient fitting it. any issues PM me.
You have to keep the BMW pump body because the RR pump will not fit the 5 series M51 engine. Then all you need to do is just be very careful fitting the EDC (top half of the pump) and be patient fitting it. any issues PM me.
