Engine tie rod

Hiya, I want to replace my lower engine tie rod and was wondering were I can get a genuine part, not sure if the bushes can be replaced or do they come as a complete unit ? It's a 1.8 k series 51 plate I've got.

Chris

I think the part number for yours will be KKH000070.

I used Rimmer Bros. But have come across Mode Land Rover who's prices seem good for genuine parts, but I haven't used them, so can't comment on the service…

Ahh cool thanks for that. Can the bushes be changed tho cous the tie bar is in good codition ?

chris51 said:

Ahh cool thanks for that. Can the bushes be changed tho cous the tie bar is in good codition ?

Click to expand...

Have a look at this thread

Check this page on the Powerflex website

Cheers
Simon

It says in the discription for the large and the small that they can cause vibration if fitted on diesel engines. Does this apply to petrol aswell or is there no difference to the orignal ones ?

chris51 said:

It says in the discription for the large and the small that they can cause vibration if fitted on diesel engines. Does this apply to petrol aswell or is there no difference to the orignal ones ?

Click to expand...

There is a bit more vibration when using the poly mounts, the severity differs between engines. The engine is located more securely through. The diesel vibrates worse then the 1.8 petrol with the V6 not really vibrating more than when using rubber mounts.