Engine oil breather to air intake adaptor

Lej · Feb 23, 2019

Hi there,

Does anyone know where I can find the adaptor part to the air filter for an oil breather hose? At the moment I have it dangling in the engine bay pumping fumes through holes into the cab...

Thank you!

dieseldog69 · Feb 23, 2019

If that is your filter housing then it is the small spigot sticking out at 90 degrees.

I used one of these when I swapped out my old tin can for a sealed housing when I fitted a snorkel.

It's a plastic skin fitting for boats, used for bilge pumps etc,.

https://www.force4.co.uk/plastic-skin-fitting.html

Just punch a hole through the intake pipe and fit with a smear of SIKA flex to seal it up and job done.

Lej · Feb 23, 2019

Sounds good enough to me, I haven't got the landy around at the moment, any chance you remember the size required?

Thank you so much, these forums are amazing!

ozzyboydeano · Feb 24, 2019

Lej said:
Sounds good enough to me, I haven't got the landy around at the moment, any chance you remember the size required?

Thank you so much, these forums are amazing!

measure the ID of your breathing hose i think its about 19 mm but dont hold me on this
also have a look into installing a decent catch can ....this can help the intercooler and intake manifold coking (even if the EGR is blanked or not )

Engine oil breather to air intake adaptor

Lej

Active Member

dieseldog69

Well-Known Member

Lej

Active Member

ozzyboydeano

Well-Known Member

Similar threads