Engine 1.8 petrol shaking at idle

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Make sure the IACV is clean and the wiring to it is cable tied to the valve body.
I've come across some bad wiring in the main harness to the engine before now too.
You could also have a coil down, effectively letting the engine run on 2 cylinders. Is the MIL on?
 
The engine starts fine, MIL is not on her to-check IACV again, the law was dirty but I did not bother to clean it perfectly
.....counts and the quality of petrol?, I noticed better gas decreases vibrations but not very much
....vibrations start after the engine reaches Optimum functioning temperature

@freelance
air leak?

where to lose???....is there any method to check


thanks for answers:)
 
Last edited:
The throttle pot has been known to cause issues.
Does it drive ok? Or does it hesitate?
My V6 is messing around at the moment, I suspect it's the fuel pump.
 
The throttle pot has been known to cause issues.
Does it drive ok? Or does it hesitate?
My V6 is messing around at the moment, I suspect it's the fuel pump.

I changed the fuel pump, especially at the start gave misfires, 3-cylinder now go shoot well without hesitation
.....vibration at idle only appears when you press the throttle disappears
 
Back
Top