Discovery 1 upper swivel pin kit fitting question

Bit of help needed please, I have ordered an upper swivel kit STC226 but it was a while ago since I removed the old one. My question is does the concetenor looking thrust washer (ABS ring I think) sandwich between the the two flat thrust washers whe installed?
I need to then put the ABS sensor back in and I assume I push all the way down as far as it will go and then the air gap will be set to whats required and/or will find its own postion as the wheel rotates.
Thanks for help.

Have a look at this, around 8 mins onwards, however if ya rebuilding the whole vid is a good reference.

Jasonmichael said:

Have a look at this, around 8 mins onwards, however if ya rebuilding the whole vid is a good reference.

Click to expand...

Great. Thanks for this!!!!