Discovery 1 (300 Tdi) presence light front a rear side

Hi everyone,
I ask for your help because I was without presence lights at the front and rear, in driver side (both). I've got the fuses and they're fine, the lamps are good too. This only happens on the driver's side. I noticed that there is no current in the front or rear ... As I installed the rear bumper and I had to put the headlights of the discovery 200, passing the wires up the headlights and winkers behind, this happened. All other lamps at the front and rear run.
I ask for your help and schemes if they have the presence lights.
Thanks

What year is the vehicle?

Set/1994

What's the number of the fuse you checked and in which fusebox? did you check if there is voltage at the fuse's cavity?

Sorry, I don't know what presence lights are, I assume they are what we call side lights ...

I'd start with simple checking with a voltmeter or multimeter that you're getting voltage at the appropriate fuses, and then start to check continuity of all the lighting wiring from switch to light. Basically find out how far the 12v goes, and they try to narrow down if or where there is a break in the wiring system.

I check with a
Voltmeter one by one the fuses of interior.
Ligh of presence are the minimum light.

In headlight switch we have minimum, maximum and the reverse light.

When i turn the headlight switch to the minimum, i dont have in front right and in rear right lights.

But in the left i have.

All other lights work, in right and left (front and rear).

Only minimum of right (driver side) dont work in front and rear...

I only have RAVE for the 1995 Discovery 1, and that shows that there are two fuses for the side lights.
Fuse F2 is for the left hand lights and F8 is for the right hand lights. Both fuses are 10 Amps.

That's why i asked about the fuse's number cos up to '94 the scheme was different and wanted to make sure that the wiring is like in the 95+ RAVE cos i have some doubts... only late 94 modells are covered by the 95+ diagram cos that was the "transition" year and on earlyer modells it's not F8

I check and are ok...

sierrafery said:

That's why i asked about the fuse's number cos up to '94 the scheme was different and wanted to make sure that the wiring is like in the 95+ RAVE cos i have some doubts... only late 94 modells are covered by the 95+ diagram cos that was the "transition" year and on earlyer modells it's not F8

Click to expand...

So no advise based on your own experience and understanding then... No 1994 MY disco's are covered in the 95 copy of Rave which is only for the 300 series.
The question you should have asked is the model year is the vehicle.

The problem is solved. It was a cut wire.
Thanks to all, for you help !

We're happy that you got it sorted.

discool said:

So no advise based on your own experience and understanding then... No 1994 MY disco's are covered in the 95 copy of Rave which is only for the 300 series.
The question you should have asked is the model year is the vehicle.

Click to expand...

And what's about in this thread?